Description: Seeks quotations for Thorabs’ Micro PL System components. A Thorlabs-based confocal cage microscope is required for achieving spatially resolved spectroscopic measurements at few micron lateral resolution with operation over the range 300-2200 nm.
HigherEducation · SC, US
Adjacent opportunities open for bidding right now.
FederalDC
Posted
Oct 14, 2026
Oct 24, 2026
This open Sources Sought notice seeks information from small businesses capable of providing a Micro Electron Diffractometer (MicroED) System for nanoscale research at Lawrence Berkeley National Laboratory. Respondents are asked to demonstrate relevant experience and provide pertinent literature, and the acquisition is classified under NAICS 334516. Responses are due October 23, 2026.
Higher EducationLA
Posted
Oct 13, 2026
Oct 29, 2026
This RFP is for the procurement of a micro reaction calorimeter.
Alabama Department of Transportation
Special DistrictAL
Posted
Oct 9, 2026
Nov 6, 2026
Work includes 74 SY removing concrete driveway, 2,655 Gal tack coat, 8,564 SY micro-milling existing pavement (approx 1.10" thru 2.00" thick), superpave bituminous concrete wearing surface layer, 3/8" maximum aggregate size mix, esal range c/d 1,397 Ton, superpave bituminous concrete upper binder layer, 3/8" maximum aggregate size mix, esal range c/d 1,075 Ton, superpave bituminous concrete upper binder layer, leveling, 3/8" maximum aggregate size mix, esal range c/d 50 Ton, 505 Ton aggregate surfacing (1" down, crusher run), 25,294 SY scrub seal, mobilization. See attached file.
Food Safety and Inspection Service
FederalDC
Posted
Oct 7, 2026
Oct 26, 2026
Requirement for the supply and installation of one Motor Control Center (MCC) and Programmable Logic Controllers (PLC) with Human-Machine Interface (HMI) control console to replace the existing hardwired devices and controls. Commissioning will be the joint responsibility of contractor and USDA personnel. Existing service is provided by three on site transformers providing 480 volts via a delta configuration with a corner grounded “B” phase. The current service configuration will not change. Special consideration must be applied to the application of variable frequency drives with the grounded “B” phase. Installation must include removal and demolition of existing devices (see Installation Comments in Appendix), cable trays and wiring. Supply must include all devices and controls, wiring, connectors, conduit and cable trays. All wiring and hardware must meet applicable local and national codes. Contractors must provide a new 600-amp service panel at back wall on northwest end of building 26. See attached file.
Solicitation files and supporting documents for this bid.
Decision makers connected to this RFP from Clemson University.
