FederalMS
Posted
Nov 16, 2026
Nov 23, 2026
Development of a Mass Production Process RFP
Requirements Specifications: Design of Tooling: The target process should integrate industrial state-of-the-art forming of sheet metal. Acceptable approaches include sheet hydroforming (e.g. fluid cell / hydro-mechanical deep drawing), conventional deep drawing, and hard tooled die forming in progressive, compound, or transfer dies of the type used to produce cold formed sheet steel structural connectors. Offerors are to propose the approach best suited to the part geometry and the production volumes stated below; forming method is not prescribed. A goal of this work is to set a benchmark for production speed and cost if the process proves viable. Cold forming of steel structural connectors common to building construction is considered the most likely fit for this part geometry and these production volumes and is the reference case against which production rate and per-part cost will be compared. Warm or hot forming is not excluded (for example warm deep drawing, or hot metal gas forming of steel or titanium), provided the offeror states the forming temperature and how it is reached and held, the material and coating system compatible with it, and the consequences for cycle time, energy consumption, equipment cost, and per-part cost in sustained volume production. Proposals are to state the intended process, the cycle time, and the degree of automation assumed at the production rate proposed (e.g. coil or blank feeding, de-stacking, inter-station transfer, and part ejection). See attached file.
