Summary
Install a new flue liner from the chimney on the roof down to the basement. Then Install a new metal weather cap with a screen around the sides to the clay flue. Once this is completed repair the top of the chimney cap with new mortar. This cap should be pitched away from the flue to keep water from sitting. Tuck Point the bricks on the chimney with matching mortar. Remove the window in the existing bath tub. Frame in the opening. Sheath to blend into the existing sheathing. Install a water barrier over the sheathing. Install matching the surrounding Stucco, blending to the existing surfaces. Electrical: Install smoker/ CO2 detectors on every floor 3 minimum. The basement should be near the gas fired appliances. Install 2 new front entry LED wall light on a motion sensor at the front door. Install a light on the back entry and a switch on the inside of the door. This light should be a LED flood style with a motion sensor. Install a new LED light in the living room replacing the one hanging by its wires. Install a new LED light in the front entry way on the inside of the ceiling. Appears to of had a box installed and Romex ran to the box currently. Install a LED light in the kitchen replacing the old florescent. Install exhaust fan light combo in the bathroom to come on with a switch. This fan will have to be ran through the attic and terminate on the roof. Plumbing: Remove the existing tub. Insulate the wall R-19 and install moisture barrier